Clock Beat Amplifier Software. Introduction This document describes how to configure the Cisco Adaptive Security Appliance (ASA) Next-Generation Firewall in order to capture the desired packets with either the Cisco Adaptive Security Device Manager (ASDM) or the CLI. Crack Architecte 3d Arcon 14 there. Prerequisites Requirements This document assumes that the ASA is fully operational and is configured in order to allow the Cisco ASDM or the CLI to make configuration changes. Components Used This document is not restricted to specific hardware or software versions.

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command. Related Products This configuration can also be used with these Cisco products: • Cisco ASA Versions 9. Mio Product Keygen For Microsoft there. 1(5) and later • Cisco ASDM Version 7.2.1 Background Information The packet capture process is useful when you troubleshoot connectivity problems or monitor suspicious activity. In addition, you can create multiple captures in order to analyze different types of traffic on multiple interfaces. Configure This section provides information that you can use in order to configure the packet capture features that are described in this document.

Note: Use the ( customers only) in order to obtain more information on the commands used in this section. Network Diagram This document uses this network setup: Configurations Note: The IP addressing schemes that are used in this configuration are not legally routable on the Internet. They are RFC 1918 addresses that are used in a lab environment. Configure Packet Capture with the ASDM Note: This example configuration is used in order to capture the packets that are transmitted during a ping from User1 (inside network) to Router1 (outside network). Complete these steps in order to configure the packet capture feature on the ASA with the ASDM: • Navigate to Wizards >Packet Capture Wizard in order to start the packet capture configuration, as shown: • The Capture Wizard opens.

• In the new window, provide the parameters that are used in order to capture the INGRESS traffic. Select inside for the Ingress Interface and provide the source and the destination IP addresses of the packets to be captured, along with their subnet mask, in the respective space provided. Also, choose the packet type to be captured by the ASA (IP is the packet type chosen here), as shown: Click Next. • Select outside for the Egress Interface and provide the source and the destination IP addresses, along with their subnet mask, in the respective spaces provided. If Network Address Translation (NAT) is performed on the Firewall, take this into consideration as well. • Enter the appropriate Packet Size and the Buffer Size in the respective space provided, as this data is required in order for the capture to take place.